25" Polar Cub Manual Laminator 1 /Each

If you are tired of mounting prints by hand, then the Polar Cub Manual Mounting Machine might be the perfect solution. The Polar Cub is available in either 25" or 38" working widths. It will save as much as half the time of mounting by hand, and will accept boards up to 1" thick. High-quality silicone rollers ensure consistent pressure and professional results, every time. Entry and exit feed tables also support the boards so you don't have to. 

The Polar Cub Mounting Machine is easy to use! To set the gap between the rollers to match the thickness of your board, place your board between the rollers and close the rollers by turning the height control knob until there is no light between the board and the rollers. Then tighten the rolls a half turn on the height control knob. If you are using the same boards all the time, this will only need to be done once. Then you can peel back the first inch of the release liner. Smoothly tack down your print to the inch of exposed adhesive. Insert the tacked edge into the mounting machine and remove the remainder of the release liner. Hold your print up so that it is smooth against the rollers. Finally, turn the handle to pull your print and board through the mounter. Your print will be mounted with pristine quality. You can then trim your print if desired. Polar Cub Starter Kit is also available! 

Features:

• Compatible with ALL types of self-stick adhesive coated mounting and foam boards up to 1" thick.

• Rugged design and ready to use out of the box

• Professional grade silicon rollers provide even pressure and insure bubble free results and any exposed adhesive on the board will not stick to the rollers

• Compact! Tables can be folded up for storage.