UniBinder 8.1 Thermal Binding Machine 1 /Each

UniBinder 8.1 Thermal Binding Machine 1 /Each
1195.000000 NewCondition InStock

UniBinder 8.1 Thermal Binding Machine 1 /Each

Item #: 04UBINDER81
Brand: Unibind


The Unibind UniBinder 8.1 is a unique thermal binding system that is so simple to use, anyone can do it! There is no complicated hole punching or alignments, and no messy glue or adhesives to manually apply...the Unibind model 8.1 is simpler than any other binding machine on the market, and will produce professional-quality soft and hard covers in as few as just 5 minutes per cycle.

UniCover thermal binding covers have a pre-applied resin in the spines. This resin liquefies once heated, while gravity pulls your pages into the resin as it does so. Once cooled, the resin solidifies and binds your pages securely. Before cooling, the crimper adjusts the metal spine to the thickness of your document, creating a finished look, while also helping to guarantee a strong and accurate bind. The Unibind UniBinder 8.1 is so easy to use, there is absolutely no special training needed. If you make a mistake, editing your book is simple and done by just re-heating the resin, removing or adding pages, and then cooling it again. There is no machine prep or warm-up time needed, it is ready to go as soon as it is plugged in. And even better, there is no maintenance required to keep the machine running at it's full potential. With the Unibind UniBinder 8.1 you can produce professional-quality thermal bound books quickly, easily, and conveniently.

UniBinder 8.1 Instructions:

   ① Put your printed sheets into the UniCover of your choice, and place your cover onto the heating element. The heat automatically turns on once you place your book down. The heating compartment is large enough to handle one book that holds 120 sheets of 20 lb. paper, or up to four books, depending on the book thicknesses.
   ② In just three minutes, the resin is heated and attached to your paged. Move the book(s) into the crimping compartment to finish the spine. When you place the book into this section, it will automatically crimp. Note: Only place one book into the crimper at a time.
   ③ Once crimped, move the book(s) onto the cooling station and allow it to sit until no longer warm.


*May vary depending on number of books, spine size, operator, and other factors.


Item #04UBINDER81
Manufacturer Part Number251UB81USC1
Suggested UserSmall Office, Medium Office
Binding StyleThermal Binding
Compatible Supplies & AccessoriesUniCover Hard Covers
UniCover Flex Covers
UniCover Spines
Power Voltage120 V, 60 Hz
Dimensions17" W x 10 ½" D x 15" H
Manufacturer's Warranty1 Year Limited Manufacturer's Warranty
Document Size8 ½" W x 11" H [Letter Size, Portrait]
System Capacity (Between Dividers)*Up to a 1/2" Thick Spine
Cycle Speed2 Minutes / Binding Cycle*
Speed2 Documents / Minute*
Approximate Annual VolumeLess than 500 Documents per Year
Product Weight (lbs)17.6
Shipping Weight (lbs)20


UniBinder 8.1 Thermal Binding Machine


Write Your Own Review
You're reviewing:UniBinder 8.1 Thermal Binding Machine 1 /Each
Your Rating

Frequent Asked Questions

Submit a New Question